Installation of terrace elements:
Install the terrace elements in a slope of 2% due to the drainage required. Take care of a frost resistant and sustainable subsurface. We recommend open joints. Always apply joint dividers such as joint crosses with a width of 3 mm. As edge boarder you can use curbstones or customary draining aluminum profiles.
GARDEN TERRACES, ENTRANCES, PATHS:
INSTALLATION ON RUBBLE
with compressed bed
Rubble sub floor (grains of 2-5 mm), thickness approximately 50 to 60 mm
Slope approximately 2%
Frost resistant subsurface (grains of 0-32 mm) such as gravel, lava, crushed stone. Thickness = 20 to 30 cm, compressed with plate compactor.
GARDEN AND ROOF TERRACES, BALCONIES, RECONSTRUCTION
Installation on concrete
Concrete slab with 2% slope to prevent standing water.
In case of surface irregularities: Level out with spacers at the bearings.
Terrace elements are laid on the bearings loosely.
INSTALLATION ON CONCRETE PAVEMENT
with mortar bags
Fill mortar into appropriate plastic bags and close afterwards.
Position the filled bags on the sub floor.
Lay the terrace elements before the mortar starts setting.